Make a 3D Bowl in GIMP [PDF]

Oregonian · **Posted:** Tue Jun 09, 2015 9:14 am **(#61)**

Very nice skritnaea. I love the pretty heart in your bowl.
:paint

gbarkovalev · **Joined:** Jan 02, 2014 **Posts:** 137

Completed tutorial

Wallace · **Posted:** Mon Oct 12, 2015 3:10 pm **(#63)**

gbarkovalev wrote:

Completed tutorial

trandoductin · **Posted:** Tue Mar 15, 2016 11:14 pm **(#64)**

I thought i would revisit this 3D bowl and add thickness to it.
and it's on a wooden table with shadow :hehe

Pat625 · **Joined:** May 12, 2015 **Posts:** 4693

I like the wooden bowl, especially the coloring of it. Did you use an e-map?

trandoductin · **Posted:** Tue Mar 15, 2016 11:29 pm **(#66)**

Pat625 wrote:

I like the wooden bowl, especially the coloring of it. Did you use an e-map?

Nope, i don't even know how to use e-map.

For the thickness edge on top of bowl, I just filled a layer with the same material as the bowl and mapped it to a plane (120 degrees of z rotation where the bowl was 30 degrees of z rotation from tutorial). and then used the ellipse select tool select top of bowl and cut that out from the plane then shrunk the selection and moved it up a bit to make the far edge a little thinner than the close edge and cut a hole into that plane.

Pat625 · **Joined:** May 12, 2015 **Posts:** 4693

Thank you. I have looked at that tutorial several times but never got it done. Hope to do it soon.

sallyanne · **Posted:** Wed Mar 16, 2016 10:05 am **(#68)**

very nice tran.
I cheated last one I did. Just ran G'MIC to get a cup and rotated it before pressing ok. Can't remember how but I cut it off where the stem started. This way I still got a thicker, rounded edge.

Have to do Oregonian's tut again one day.
This is done with the cup

trandoductin · **Posted:** Wed Mar 16, 2016 12:06 pm **(#69)**

The rounded edge is real nice Sallyanne,
you will have to share the exact steps how you did it.